Sat Buddy 2 Satellite Alignment Meter | Finder

Features Include

• Heavy Duty Replaceable F-Connectors (easy change with one 7/16" wrench)
• 22 KHz tone mode to control multiswitches and multi-LNB dishes
• Bright LED display, easy to read even in direct sunlight
• Strong audible tone
• Internal rechargeable NiMH battery
• Able to power LNB from internal battery or IRD
• Rugged, compact, weather resistant design
• Includes DC Cigaretter Lighter Charger, AC Wall Charger
• Short circuit protection
• Switches 22KHz On/Off
• High Current Limit Level of 600mA that allows it to work with the Dish Pro Plus and Dish 1000.2
• 950-2150 input frequency
• Tests Coax Cable Runs
• Selectable Audio On/Off
• Able to check IRD Set Top Box Receiver Voltage, LNB current amps
• Works with all LNBs
• Able to align antenna quickly and reliably without the receiver

Measurements

• Signal strength (RF energy 950 to 2150 MHz)
• LNB current draw (mA)
• Voltage supplied by the IRD set top box
• Internal battery voltage

Specifications

• Frequency range: 950 to 2150 MHz
• Impedance: 75 Ω
• Measurable input level: -48 to -8 dBm total power, -60 to -20 dBm per transponder
• Insertion loss: 14 dB (950 to 1450 MHz), 22 dB (1450 to 2150 MHz)
• Size (H x W x D): 6.5" x 2.7" x 1.1", 1.5 lbs (16.5cm) x (6.9cm) x (2.8cm), 700g
• Temperature range: 0°F to 125°F (-17°C to +50°C)
• Connectors: Type F female (field replaceable)
• Power: Uses IRD power when connected, otherwise uses internal battery. IRD voltage loss through the SAT Buddy is 1.3 V. Current consumed by the SAT Buddy is 90 mA.
• LNB Power: Current limited at 600 mA
• Internal Battery Pack: Rechargeable 12 cell NiMH 300 mAh, 12-16 V nominal, automatic shutoff, 1.8 hours typical use per charge.
• Battery Charge Time: ±10 hours from wall charger
• Wall Charger Output: 12 VDC, 200 mA, center pin positive, 2.1mm I.D
• Signal Measure Mode
• Signal Level Display
• Bargraph LEDs left row x 10, right row x 1
• Audible Tone
• Dual beep rate with solid tone at peak
• Current/Voltage Mode
• LNB Current Draw: 0 to 500 mA (each LED segment is 50 A)
• LNB Supply Voltage: 10 to 20 volts (each LED segment is 1V, above 9V)